| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in Application Quality of Experience (AppQoE) and Unified Threat Defense (UTD) on Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to the mishandling of a crafted packet stream through the AppQoE or UTD application. An attacker could exploit this vulnerability by sending a crafted packet stream through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the access control list (ACL) processing on MPLS interfaces in the ingress direction of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass a configured ACL.
This vulnerability is due to incomplete support for this feature. An attacker could exploit this vulnerability by attempting to send traffic through an affected device. A successful exploit could allow the attacker to bypass an ACL on the affected device.
There are workarounds that address this vulnerability.
This advisory is part of the September 2023 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see Cisco Event Response: September 2023 Semiannual Cisco IOS XR Software Security Advisory Bundled Publication . |
| A vulnerability in the classic access control list (ACL) compression feature of Cisco IOS XR Software could allow an unauthenticated, remote attacker to bypass the protection that is offered by a configured ACL on an affected device.
This vulnerability is due to incorrect destination address range encoding in the compression module of an ACL that is applied to an interface of an affected device. An attacker could exploit this vulnerability by sending traffic through the affected device that should be denied by the configured ACL. A successful exploit could allow the attacker to bypass configured ACL protections on the affected device, allowing the attacker to access trusted networks that the device might be protecting.
There are workarounds that address this vulnerability.
This advisory is part of the September 2023 release of the Cisco IOS XR Software Security Advisory Bundled Publication. For a complete list of the advisories and links to them, see Cisco Event Response: September 2023 Semiannual Cisco IOS XR Software Security Advisory Bundled Publication . |
| A vulnerability in the Multicast Leaf Recycle Elimination (mLRE) feature of Cisco IOS XE Software for Cisco ASR 1000 Series Aggregation Services Routers could allow an unauthenticated, remote attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition.
This vulnerability is due to incorrect handling of certain IPv6 multicast packets when they are fanned out more than seven times on an affected device. An attacker could exploit this vulnerability by sending a specific IPv6 multicast or IPv6 multicast VPN (MVPNv6) packet through the affected device. A successful exploit could allow the attacker to cause a reload of the affected device, resulting in a DoS condition. |
| A vulnerability in the Cisco IOx application hosting subsystem of Cisco IOS XE Software could allow an authenticated, local attacker to elevate privileges to root on an affected device.
This vulnerability is due to insufficient restrictions on the hosted application. An attacker could exploit this vulnerability by logging in to and then escaping the Cisco IOx application container. A successful exploit could allow the attacker to execute arbitrary commands on the underlying operating system with root privileges. |
| A vulnerability in the web-based UI (web UI) of Cisco IOS XE Software could allow an unauthenticated, remote attacker to conduct a cross-site request forgery (CSRF) attack on an affected system. The vulnerability is due to insufficient CSRF protections for the web UI on an affected device. An attacker could exploit this vulnerability by persuading a user of the interface to follow a malicious link. A successful exploit could allow the attacker to perform arbitrary actions with the privilege level of the affected user. If the user has administrative privileges, the attacker could alter the configuration, execute commands, or reload an affected device. This vulnerability affects Cisco devices that are running a vulnerable release of Cisco IOS XE Software with the HTTP Server feature enabled. The default state of the HTTP Server feature is version dependent. |
| A vulnerability in the health check RPM of Cisco IOS XR Software could allow an unauthenticated, remote attacker to access the Redis instance that is running within the NOSi container. This vulnerability exists because the health check RPM opens TCP port 6379 by default upon activation. An attacker could exploit this vulnerability by connecting to the Redis instance on the open port. A successful exploit could allow the attacker to write to the Redis in-memory database, write arbitrary files to the container filesystem, and retrieve information about the Redis database. Given the configuration of the sandboxed container that the Redis instance runs in, a remote attacker would be unable to execute remote code or abuse the integrity of the Cisco IOS XR Software host system. |
| A vulnerability in the Cisco IOx application hosting environment could allow an authenticated, remote attacker to execute arbitrary commands as root on the underlying host operating system. This vulnerability is due to incomplete sanitization of parameters that are passed in for activation of an application. An attacker could exploit this vulnerability by deploying and activating an application in the Cisco IOx application hosting environment with a crafted activation payload file. A successful exploit could allow the attacker to execute arbitrary commands as root on the underlying host operating system. |
| A vulnerability in the bidirectional forwarding detection (BFD) hardware offload feature of Cisco IOS XR Software for Cisco ASR 9000 Series Aggregation Services Routers, ASR 9902 Compact High-Performance Routers, and ASR 9903 Compact High-Performance Routers could allow an unauthenticated, remote attacker to cause a line card to reset, resulting in a denial of service (DoS) condition. This vulnerability is due to the incorrect handling of malformed BFD packets that are received on line cards where the BFD hardware offload feature is enabled. An attacker could exploit this vulnerability by sending a crafted IPv4 BFD packet to an affected device. A successful exploit could allow the attacker to cause line card exceptions or a hard reset, resulting in loss of traffic over that line card while the line card reloads. |
| A vulnerability in the implementation of the IPv4 Virtual Fragmentation Reassembly (VFR) feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper reassembly of large packets that occurs when VFR is enabled on either a tunnel interface or on a physical interface that is configured with a maximum transmission unit (MTU) greater than 4,615 bytes. An attacker could exploit this vulnerability by sending fragmented packets through a VFR-enabled interface on an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the CLI of Cisco IOS XE SD-WAN Software could allow an authenticated, local attacker to execute arbitrary commands with elevated privileges. This vulnerability is due to insufficient input validation by the system CLI. An attacker with privileges to run commands could exploit this vulnerability by first authenticating to an affected device using either local terminal access or a management shell interface and then submitting crafted input to the system CLI. A successful exploit could allow the attacker to execute commands on the underlying operating system with root-level privileges. An attacker with limited user privileges could use this vulnerability to gain complete control over the system. Note: For additional information about specific impacts, see the Details section of this advisory. |
| A vulnerability in the fragmentation handling code of tunnel protocol packets in Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected system to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to the improper handling of large fragmented tunnel protocol packets. One example of a tunnel protocol is Generic Routing Encapsulation (GRE). An attacker could exploit this vulnerability by sending crafted fragmented packets to an affected system. A successful exploit could allow the attacker to cause the affected system to reload, resulting in a DoS condition. Note: Only traffic directed to the affected system can be used to exploit this vulnerability. |
| A vulnerability in the IPv6 DHCP version 6 (DHCPv6) relay and server features of Cisco IOS and IOS XE Software could allow an unauthenticated, remote attacker to trigger a denial of service (DoS) condition. This vulnerability is due to insufficient validation of data boundaries. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly. |
| A vulnerability in Cisco IOS XE Software for Cisco Catalyst 9300 Series Switches could allow an authenticated, local attacker with level-15 privileges or an unauthenticated attacker with physical access to the device to execute persistent code at boot time and break the chain of trust. This vulnerability is due to errors that occur when retrieving the public release key that is used for image signature verification. An attacker could exploit this vulnerability by modifying specific variables in the Serial Peripheral Interface (SPI) flash memory of an affected device. A successful exploit could allow the attacker to execute persistent code on the underlying operating system. Note: In Cisco IOS XE Software releases 16.11.1 and later, the complexity of an attack using this vulnerability is high. However, an attacker with level-15 privileges could easily downgrade the Cisco IOS XE Software on a device to a release that would lower the attack complexity. |
| A vulnerability in the GRand Unified Bootloader (GRUB) for Cisco IOS XR Software could allow an unauthenticated attacker with physical access to the device to view sensitive files on the console using the GRUB bootloader command line. This vulnerability is due to the inclusion of unnecessary commands within the GRUB environment that allow sensitive files to be viewed. An attacker could exploit this vulnerability by being connected to the console port of the Cisco IOS XR device when the device is power-cycled. A successful exploit could allow the attacker to view sensitive files that could be used to conduct additional attacks against the device. |
| A vulnerability in the Meraki onboarding feature of Cisco IOS XE Software could allow an authenticated, local attacker to gain root level privileges on an affected device. This vulnerability is due to insufficient memory protection in the Meraki onboarding feature of an affected device. An attacker could exploit this vulnerability by modifying the Meraki registration parameters. A successful exploit could allow the attacker to elevate privileges to root. |
| A vulnerability in the management CLI of Cisco access point (AP) software could allow an authenticated, local attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient input validation of commands supplied by the user. An attacker could exploit this vulnerability by authenticating to a device and submitting crafted input to the affected command. A successful exploit could allow the attacker to cause an affected device to reload spontaneously, resulting in a DoS condition. |
| A vulnerability in the web UI of Cisco IOS XE Software could allow an authenticated, remote attacker to perform a directory traversal and access resources that are outside the filesystem mountpoint of the web UI. This vulnerability is due to an insufficient security configuration. An attacker could exploit this vulnerability by sending a crafted request to the web UI. A successful exploit could allow the attacker to gain read access to files that are outside the filesystem mountpoint of the web UI. Note: These files are located on a restricted filesystem that is maintained for the web UI. There is no ability to write to any files on this filesystem. |
| A vulnerability in the HTTP-based client profiling feature of Cisco IOS XE Software for Wireless LAN Controllers (WLCs) could allow an unauthenticated, adjacent attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient input validation of received traffic. An attacker could exploit this vulnerability by sending crafted traffic through a wireless access point. A successful exploit could allow the attacker to cause CPU utilization to increase, which could result in a DoS condition on an affected device and could cause new wireless client associations to fail. Once the offending traffic stops, the affected system will return to an operational state and new client associations will succeed. |
| A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position. |
